DPA 4015C Compact Wide Cardioid Microphone
$919.00
- Brand: DPA Microphones
- Product Code: 1500000408388
- Availability: In Stock
High Quality 4015C Compact Wide Cardioid Mic by DPA Microphones
The DPA Microphones 4015C Compact Wide Cardioid Mic is an excellent spot mic as a fill-in between an omni and a cardioid. The compact version is easier to position than other cardioid microphones. Visually discreet, the 4015C Compact Wide Cardioid Mic represents an indispensably low-profile solution for audio engineers and set designers alike. Tremendously precise and natural-sounding, these mics will certainly exceed expectations when used on choirs, percussion setups, grand pianos, wind instruments and much more.Features
- Low profile – wide pickup area
- Natural reproduction
- Directional ambience pickup
- Exceptional for vocals
- Modular flexibility
- Directional pattern: Wide cardioid
- Principle of operation: Pressure gradient
- Cartridge type: Pre-polarized condenser
- Frequency response: 20 Hz - 20 kHz
- Effective frequency range, ±2 dB, at 60 cm (23.6 in): 40 Hz - 20 kHz
- Sensitivity, nominal, ±2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa
- Equivalent noise level, A-weighted: Typ. 18 dB(A) re. 20 µPa (max. 20 dB(A))
- Equivalent noise level, ITU-R BS.468-4: Typ. 25 dB (max. 27 dB)
- Distortion, THD < 1%: 136 dB SPL RMS, 139 dB SPL peak
- Dynamic range: Typ. 121 dB
- Max. SPL, THD 10%: 152 dB SPL peak
- Rated output impedance: 100 ohm
- Minimum load impedance: 2 k ohm
- Cable drive capability: 100 m (328 ft)
- Output balance principle: Impedance balancing with Active Drive
- Common mode rejection ratio (CMRR): > 50 dB
- Power supply (for full performance): P48 (Phantom Power)
- Current consumption: 2.8 mA
- Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
- Color: Matte black
- Weight: 58 g (2 oz)
- Microphone diameter: 0.75”
- Capsule diameter: 0.75”
- Microphone length: 2.5”
- Maximum output voltage, RMS: 4.5 V
- Polarity: +V at pin 2 for positive sound pressure
- Temperature range: -40°C to 45°C (-40°F to 113°F)
- Relative humidity (RH): Up to 90%
- Matching tolerance (frequency response and sensitivity): ±1 dB
- Phase deviation for kit: < 10°
